
Starting up and configuring Meridian Mail 13-9
Configuring Meridian Mail
Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999
9 Check the status of each DSP port to make sure they are all
functional. Press the [DSP Port Status] softkey. DSP Port
Status should be Idle for all ports. See the illustration below.
Note:
For a full description of this screen, see the
System
Administration Guide
(NTP 555-7001-301). This document also
describes how to run out-of-service diagnostics for ports that
do not come to idle status on bootup or to active status during
the testing described in steps 10 to 12.
10 While you watch this screen, dial the voice messaging DN from
a phone connected to the switch.
11 Note which channels become active.
12 Ensure there is no noise on the line.
13 Release and repeat steps 10 to 12 until all of the ports have
been tested.
14 If everything appears to be in order, press [Exit] to return to the
Logon screen.
15 Replace the faceplates that cover the disk/tape drive areas.
16 Install the I/O covers and the front and rear doors of the
modules.
Step Action
DSP Port Status
Select a softkey >
Exit
DSP Port Status
Node 1 2 3 4 5 6 7 8 9 10 11 12
1 . . . . . . . . . . . .
a = Active/In Use . = Idle O = Out of Service ? = Unknown
F = Faulty P = Pending U = Unequipped R = NoResource
L = Loading C = CourtesyDown
Ports
g101075
Komentáře k této Příručce