Seagate ST3390N Instalační příručka stáhnout pdf (Strana 177)

100

101

Installing the Meridian Mail to PBX interface 11-21

Installing the enhanced serial data interface card

Standard 1.0 Modular Option EC Installation and Maintenance Guide November 1999

To complete this procedure, you may need to refer to Circuit

Card Installation (NTP 553-3001-211).

Note: Meridian 1 cards are hot-pluggable. However, to remove

or install a card, you must first disable the card.

Installing the ESDI

card

To install the ESDI card, follow these steps.

Step Action

1 Log on to the Meridian 1.

2 Load Overlay 22 and print out the configuration record. Refer to

the following table for instructions.

3 Refer to the configuration record and select an available device

number (DNUM), Application Module Link (AML number), and

Value Added Server Identifier (VSID).

The DNUMs are the same numbers as the TTYs.

To choose an available DNUM, choose any unused TTY in the

range 0–15. Preferably, select the same number for all three

numbers. Record these numbers. You will need them when you

configure the link and the ESDI.

4 Unpack and inspect the ESDI card, and check that there are no

obviously loose or bent parts.

5 Set the ESDI faceplate switch to “DIS.”

6 Set the option jumpers for the port you are going to use on the

ESDI card according to the illustration in step 7.

Prompts Responses Description

REQ PRT

TYPE CFN Configuration data block

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 467 468

Komentáře k této Příručce

Žádné komentáře

Seagate ST3390N Instalační příručka Strana 177

Komentáře k této Příručce

Související produkty a manuály pro Sítě Seagate ST3390N