Seagate ST3655N Instalační příručka

. . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . .ST3390N, ST3655N. . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . .

6. Attaching the 50-pin SCSI interface cable. Attach one endof the cable to the drive interface connector and the other endto the interface connector

InterfaceconnectorPowerconnectorFigure 3. Recommended mounting orientationsST3390N, ST3655N Installation Guide, Rev. A 9

CMOS setup for AT systemsWhen you start up your drive for the first time, enter the CMOSSETUP routine. This routine enables you to define a new drive

If you choose to low-level format your drive, use the DOS DEBUGutility. The most common DEBUG low-level formatting commandis g=c800:5. Verify the BIOS

To high-level format the drive, perform the following operations:1. Use the FORMAT utility to high-level format the drive. Referto your DOS manual for

are not crimped or damaged in any way. Keeping extra cableson hand for troubleshooting saves time and frustration.For each ribbon cable, verify that p

Before continuing, carefully read the preceding checklist. Youneed to refer to the introductory material to effectively use thefollowing information.

• Turn off the system and wait 20 seconds. Turn it back on andmake sure the drive spins up. If the drive does not spin up,check the drive power cable.

During the DOS high-level format, the drive keeps retryinghard errors and reporting the following message. “Attempt-ing to recover allocation units. .

SeaFONE. 408/438-8222You can talk to a technical support specialist between8:00 A.M. and 5:00 P.M. (Pacific time), Monday through Friday.SeaFO

© 1993 Seagate Technology, Inc. All rights reservedPublication Number: 36235-001, Rev. AJune 1993Seagate®, Seagate Technology®, and the Seagate

Seagate Technology, Inc.920 Disc Drive, Scotts Valley, CA 95066, USAPublication Number: 36235-001, Rev. A, Printed in USA

Read before you begin...Application. Your drive is designed for IBM AT and compatiblepersonal computers, Sun, Macintosh and other SCSI systems.Turn of

Radio and television interference. This product complies withClass B limits for radio noise emissions from computer equipmentas set out in the radio i

SCSI ID, install jumpers on the SCSI ID jumper block asshown in Figure 1 on page 6.2. Installing or removing terminating resistors. SCS

4. Installing jumpers on the active/passive terminationjumper block. If you removed the terminating resistors fromthe drive according to the inst

Attaching cablesRefer to Figure 1 on page 6 and Figure 2 on page 7 for thelocations of the connectors and jumper blocks.1. Turn off the system po

43SCSI ID = 0SCSI ID = 1SCSI ID = 2SCSI ID = 3SCSI ID = 7SCSI ID = 4SCSI ID = 5SCSI ID = 6MSB21J5. SCSI IDjumper blockJ4. Interfaceconnector (pin

J8. User-configuration jumper block1112910785634131412Circuit board1–67891011–20Reserved.Ext. spindle sync.Clock groundRemote LED + R