Seagate ST31230N/ND Instalační příručka stáhnout pdf (Strana 138)

10-4 Configuring the Meridian 1 Option 11 switch

Determining a new AML/ESDI device number

Standard 1.0 Option 11 EC Installation and Maintenance Guide November 1999

Determining a new AML/ESDI device number

Assigning the SDI port

device number

The SDI/DCH card has four ports, but you can use only two

in the ESDI mode for an AML link (Ports 1 and 3). You will

assign a logical device number to each usable port (range

0-15) in Overlay 17. The device number identifies the AML

port. Meridian 1 Overlay 17 uses the device number to

establish the software link with Meridian Mail.

To determine the available ports before assigning the AML

logical device number, first print the Meridian 1

configuration using Overlay 22 as shown below. To assign

the AML logical device number, follow these steps.

Step Action

1 Log on to Meridian 1 and print out the configuration

record from Overlay 22.

Prompts Responses Descriptions

REQ PRT

TYPE CFN Configuration

data block

2 Refer to the configuration record, then select the

following available numbers:

• Device number (DNUM)

• Application Module link (AML number)

• Value Added Server Identifier (VSID)

The DNUMs are the same numbers as TTYs

Note: To choose an available DNUM, select any

unused TTY in the range of 0–15 as the DNUM.

Preferably, select the same number for all three

numbers. This should be a number that has not

already been assigned to an AML link or VSID. Write

the numbers down. You will need them when

configuring the link and the SDI/DCH card.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 271 272

Žádné komentáře

Seagate ST31230N/ND Instalační příručka Strana 138