scrambling in Trainer.
o ST8366 SATA Trainer at 3G or 6G misses
ALIGN in Wait For.
o ST8358 Trainer Link in Manual OOB then
switch AUTO generates a Corrupted
COMINIT on CONNECT command.
o ST8338 SATA Compliance - SSD fails DOF-
02 test when test is run in sequence
o ST8335 Device Emulator is only able to load
one imported .stf file
o ST7590 VSE cannot get speed of Trace
Event: In.LinkSpeed added to VSE manual
o ST7591 VSE: SendLevelOnly(_LINK) does
not send all link frames
o ST7566 Analyzer fails to filter out idle traffic
o ST7356 SATA Compliance - Two issues with
SSP-02 test
o ST7354 Host Emulation Script no longer runs
to completion
o ST6948 Cascaded M6-4 units ID not shown
on active device tabs
o ST6947 Find device reported wrong
connection speed for some drives behind
expander
o ST6945 Find Device tool reports size
incorrectly for 2TB drives
o ST6861 SATA Compliance test suite does
not support drives with block sizes other than
512 bytes
o ST6803 Need to decode SCSI command
"ATA PASS THROUGH 16" (Opcode 0x85)
o ST6622 After starting and stopping a
scenario about 20 times, jammer fails to pass
traffic correctly
o ST6549 SATA Protocol Suite: Performance
Tab doesn't include Trusted DMA commands
in calculations
o ST6197 SATA Compliance - Suggested
revisions to NCQ-03 from SSD manufacturer
o ST6165 Host Emulator - New "Repeat
inserting HOLD sequence" feature sometimes
injects HOLD outside of frames
o ST5902 Device Emulator - Cannot inject
"Field of Frame" errors into User Defined
Commands
o ST5871 SAS Verification - Seagate
Yellowjacket drive gets N/A result on NACA
test because default buffer is too small
o ST5528 SAS Verification - "<< Remove"
button minor issue
o ST5127 Find Device does not extract enough
information for successful Target Emulation
o Issues with SAS Verification tests 7.4.2 , 7.4.6
, 7.4.1, 9.2.2 , 9.4.2 and 10.1.7
o A rare Trainer hang when coming out of OOB.
Komentáře k této Příručce